| #1 |
Using 2” x 4” lumber cut small wedges to fit your crown
molding size |
Exterior Compressor Unit
(Remember to wear safety goggles):
| #2 |
Install 2x4 wedges at 16” on center with construction
adhesive (Hold back 3inches from the corner for your miter
cut). |
| #3 |
Use small Finishing Nails to hold the wedge in place
until the adhesive dries. |
| #4 |
Place small pieces of blue painters tape at each
wedge. This tape will help you find the wedges when you are
ready to install your crown. |
| #5 |
Install crown by nailing (at blue tape) to the
2x4 wedges. |
| #6 |
Caulk crown to the wall and ceiling (make sure to
wipe off excess caulk with a damp cloth or sponge). |
|
** NOTE: Pre-prime and pre-paint crown. After installation,
just touch-up paint as needed. |
|
ANOTHER PROJECT WELL DONE!
|
